Supply- and exhaust-air units for small volumes of air
SUITABLE FOR AIR FLOW BETWEEN 0.03–1.4 m³/s
Adaptable to a variety of conditions, each machine is modified and customized to meet customer needs. Our units inhold the components needed for air filtration and heating, as well as the necessary electrical and automation equipment.
Machines are built with steel-wool-steel structure, 30 mm thick rock wool used for insulation. Vent inholds a heating radiator, dampers, high quality air filters and a spare filter kit. The fans are mainly EC motors, but the fan type can be changed according to the customer’s request. For AC and PM motors, the fan always includes a frequency converter, unless otherwise requested.
Units can be installed eighter floor or ceiling. They are available also in several parts for easy erection or as vertical models for tight spots. The unit can also be modified for exhaust air. The heating radiator can be either fluid coil or electric as requested.
Water, glycol or direct evaporative cooling radiators, pre-filters, mufflers, radiator mixing groups and circulation pumps are available as accessories for our machines, as well as a wide range of sensors and meters. The unit can be equipped with an electrical control panel without or with automation. The control panel can also be delivered as a stand-alone unit and installed on site at the desired location. The customer can also supply the factory with the components of his choice for installation into the machine.
For AMCS electric panel heaters and AMCV water-circulation heaters
The information below presents air quantities for a standard unit that has been equipped with a water-circulation heater and an EU6 filter. An electric panel heater decreases the pressure drop by 10–40 Pa.
FUSE SIZES, AMCS
The table below presents the unit’s sound levels after a 1,200-mm damper by octave band with a nominal air flow.